Replacing fuses in your home is one of the things you should take care of if you are a homeowner. Fuses are essential for circuit breakers to work properly. When they go out, you will find that all sorts of things can be quite dangerous because you do not know when a circuit breaker will trip and cause injuries.
You may never discover what the reason behind the fuse problem is until someone gets hurt or the house burns down. If you have circuit breakers in your home, you should call a professional before replacing fuses on your own. Doing so could void the warranty on your appliances.
You should also know how to replace fuses in case there are problems with your circuit breakers that you did not detect. There are a number of reasons why you might want to replace the fuses in your home. If you think you may have a fuse box that needs to be replaced, then replacing the fuses may be necessary.
One sign that you need to replace the fuses is if you hear a loud popping noise when the breaker is tripped. This means that the fuse is about to blow. When replacing fuses, you need to take the following steps to ensure they are properly replaced.
The first step is to disconnect the power from the circuit. You will need to do this outside in the open. Look for a metal tab near each of the fuses that covers the terminal. Release this tab by pulling on the wire that is covering the wire.
Now unscrew the two screws that are holding the plug in place. Remove the plug from the outlet. Place the new plug and reconnect the wires. Make sure that the wires are not damaged by pushing them back into the plug.
The next step is to remove the old fuse. This can be done by unscrewing the cover plate on the fuse. You will need to look inside the fuse box to find the wires that are carrying the current. Pull these out to replace the fuses. When replacing the fuses, make sure they are close to the same rating as the ones you just removed. If they are not then you may have to buy new ones.
Once you have the wires, you will need to reassemble the power plug. Lay the new plug inside the outlet. Reconnect the power cord to the electrical circuit. You may need to install some new plugs in the outlet. Put everything back together and test the plug to ensure it works. Check out these fuses for a valuable set that lasts very long.
When replacing fuses, remember to always turn off the power at the breaker panel before working on the fuse. Wearing wire gloves and a safety mask will prevent any problems with your hands and face from the flying fuses. Replacing fuses can be dangerous if you do not know what you are doing.
When the power has been shut off, take off the cover plate of the fuse and remove the metal tab that holds the wires in place. You will see several screws that are screwed together. The tab will be facing away from you when you remove it. Take the new plug and screw it into the hole. Tighten the screw carefully but do not overtighten it.
Plug the new plug into the hole. Apply the wire stripper to the wire that is attached to the end of the wire. Work the wire stripper over the wire until it glides easily along the exposed wire. If there are stripped ends, strip them off and use the wire stripper to clean up any extra dirt.
Using your new screwdriver, gently pry the terminals from the old fuses. Remove both the terminals from the plug. It may take a few pulls on the socket to remove all of the insulation on each strip of wire. You should be left with one, very small, stripped wire.
Cut the new wire to the same size as the old one. Then attach the two wires to the positive and negative terminals on the fuse holder using pliers. You may need to use your soldering iron to attach the soldering lead to the wires that are not already soldered in place.
You may have to use some electrical tape to ensure that the wire does not short or become damaged while soldering. Finally, attach the end of the new wire to the negative terminal and to the positive terminal on the fuse holder.
